2. OPERATION MESSAGES ON SETTING AND DISPLAY UNIT
2.1 Operation Errors
I - 47
Error No. Error message Details
E07 RESET END
∆
• The input/output operations were forcibly stopped by reset‚ etc.
(including EMG).
E08 PHYSICAL ERR
×
• The input/output parameter setting or input/output unit side
setting was incorrect.
E09 TIME OUT
×
• The input/output unit parameter "#9116 TIME-OUT SET" setting
was too short.
• There is no EOB code in the machining program.
E10 MEMORY OVER
×
• The program cannot be written because the memory capacity is
exceeded.
• This error occurs when the MDI data setting on the MDI screen
exceeds 500 characters‚ or when saving MDl‚ editing or making a
program on the edit screen‚ input on the data input/output
screen‚ program copy‚ etc.
E11 PROG. No. DUPLI
∆
• When registering a machining program in the memory‚ a
program with the same No. as the designated program No. was
found in the memory. Refer to the program file to find a program
No. not being used‚ and reset the program No.
• A program with the same No. as the machining program to be
copied from the memory was found in the IC card.
• This error occurs during MDI registration in the MDI screen or
during creation of a program in the edit screen.
E12 FILE ENTRY
OVER
×
• When registering a machining program in the memory‚ the No. of
programs determined in the specifications is exceeded‚
preventing registration.
This error occurs during MDI registration in the MDI screen‚
creation of a program in the edit screen‚ data input in the data
input/output screen‚ and program copy.
E13 NB NOT FOUND
∆
• The block with the designated sequence No. or block No. does
not exist in the designated program.
E14 PROG. NOT
FOUND
∆
• The designated program is not found in the memory.
• A machining program in the IC card was searched during
emergency stop.
• The corresponding program No. was not found with operation
search in the tape or memory operation mode during graphic
check.
E15 EDIT LOCK B
×
• An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program B was attempted.
E16 EDIT LOCK C
×
• An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program C was attempted.
E17 PARITY H ERR
×
• A parity H error was detected during data input‚ etc.
• Check the paper tape or input device. This error may occur if the
paper tape is dirtied with oil‚ etc.
E18 PARITY V ERR
×
• A parity V error was detected during data input.
• Check the paper tape to see whether the number of characters in
the significant information section of a block is odd.
• Also check the state (cable wiring‚ noise measures‚ etc.) of the
connected equipment.
England 
Deutschland 
France 
Italia 
Polska 
United Kingdom 
Россия 
Nederland 
España 
Magyarország 
Sverige 
România 
Portugal 
Colombia 
Suomi 
New Zealand 
Česká republika 
Türkiye 
Danmark 
日本