2. OPERATION MESSAGES ON SETTING AND DISPLAY UNIT
2.1 Operation Errors
I - 50
Error No. Error message Details
E62 I/O PARAM ERR
∆
• The "EIA code" data set for I/O parameter is of an unusable
code.
• The unusable codes are those used as the EIA standard codes
and the even hole codes.
• System configuration data output operation was executed
without using the data ASCII. Set "0" to EIA output, "1" to data
ASCII in the I/O device parameters.
E64 PROGRAM No.
ERR
∆
• The same No. as the program No. designated for program copy
was found in the memory.
• Restart search for the machining program of the IC card/tape
was attempted in the tape mode (tape/IC card operation) without
an operation search ahead of time.
• During program input‚ the first character of the machining
program block is the program No. address "O" or "L".
E65 PROG. No. DUPLl
∆
• During program input‚ the same No. as the specified program
was found in the memory.
E66 NO PROG.
NUMBER
∆
• During program input‚ the program No. was not found in the input
source external memory device and a program No. was not
designated on the screen’s data setting area. Set the program
No.‚ and input again.
E69 PROG. CHECK
MODE
×
• Search (operation search) was attempted during program check
(continuous or step).
• Retry search after the program check is completed‚ or after
resetting the program search
E70 TOOL No. DUPLl
∆
• A tool No. already registered was newly registered on the tool life
management screen.
E71 TOOL ENTRY
OVER
×
• Registration of data exceeding the max. No. of registerable tools
was attempted on the tool life management screen.
• When inputting the tool offset data onto tape‚ a compensation
number exceeding the specifications range was specified‚ and
that block could not be input. If the INPUT key is pressed again in
the input screen’ the input will continue from the next block.
E73 CAN’T
CALCULATE
×
• The coordinate value of the hole center cannot be obtained.
• Reset the measurement point, which must not applied to the
following conditions.
The measurement A point is the same as the Y coordinate of the C point.
The measurement B is the same as the Y coordinate of the C point.
The slope of the line through A and C point is the same as the slope of the line
through B and C point.
E74 MENU
IMPOSSIBLE
×
• Press the operation menu "= Input" or "+ input" during the tool
measurement.
• Press the operation menu "= Input" or "+ input" during the
manual value command mode.
• Press the screen selection menu on which "↓" is displayed
during the tool measurement.
• Press the screen selection menu on which "↓" is displayed
during the manual value command mode.
England 
Deutschland 
France 
Italia 
Polska 
United Kingdom 
Россия 
Nederland 
España 
Magyarország 
Sverige 
România 
Portugal 
Colombia 
Suomi 
New Zealand 
Česká republika 
Türkiye 
Danmark 
日本