Manuel De L'utilisateur Whirlpool Système D'eau Whes30 [25/39 Pages]

Whirlpool système d'eau WHES30

Clean / Clear Water Iron Removal

This feature is beneficial on water supplies containing iron and/or high amounts of sediments (sand,

silt, dirt, etc.). When set to “ON”, an additional backwash and fast rinse cycle will occur first,

preceeding the normal regeneration sequence. This provides extra cleaning of the resin bed before it

is regenerated with the salt brine . To conserve water set this feature “OFF” if your water supply does

not contain iron or sediments.

1. Press and hold the

PROGRAM button until the following screen is displayed.

Once in this display, press the PROGRAM button twice and one of the following two displays

is shown. Both displays will show the word “Clean”.

2. Press the

Up or

−

Down buttons to set On or Off.

Clean Feature Minutes

Adjust the length of the Clean/Clear Water Iron Removal feature, f rom 1 to 15 minutes in length. To

change this cycle time, use the UP button to increase the time, or the DOWN button to shorten the time.

If you are using this feature the length of the extra backwash cycle automatically sets to 3 minutes.

1. Press and hold the

PROGRAM button until the following screen is displayed.

Once in this display, press the PROGRAM button three times and following display is shown.

2. Press the

Up or

−

Down buttons to set number of minutes.