The RC-87 wireless wrist button MKT51001
2
The RC-87 wireless wrist button
The RC-87 is a component of Jablotron’s Oasis 80 alarm system.
It allows users to trigger panic alarms or to control appliances
remotely. It is especially designed for personal calls for help. The
battery-powered wireless button communicates via OASIS radio
protocol.
The button can be worn on your wrist like a watch or it can hang
around your neck (an appropriate strap is supplied in the package).
Caution: When hanging around the neck, the strap must be
equipped with a mechanical release which disconnects the strap
whenever the loading force exceeds 40N.
Enrolling to an Oasis control panel
The button can be used with an Oasis control panel for triggering
panic alarms. Take the following steps to enroll the button:
1. Enter enrollment mode on the control panel by keying in “1” in
Service mode (the desired device address can be chosen by the
arrow keys).
2. Hold the button until you see the button’s LED flash once.
3. The button will enroll to the chosen position.
4. Exit enrollment mode by pressing “#”.
The control panel’s natural reaction to the button is a Panic alarm. A
different reaction can be programmed if desired.
The wrist button can be enroled by inserting the battery (step 2).
Functionality
By factory default, the button reacts to pressing with beeps and
flashes. This way it is signalled that the time is getting close for alarm
triggering. If you re-press the button within 5 seconds, the pre-
alarm condition will be cancelled. If no cancellation occurs, an alarm
signal will be sent after 5 seconds. This feature allows the user to
cancel accidental button pressing.
The button can be reconfigured to another function as follows:
1. Open the button unit (release 4 screws from below) and pull out
the electronics.
2. Disconnect the battery from the holder (it can be pulled out using
a thin tool). Wait for 15 seconds.
3. Press and hold the button with one hand and insert the battery
with your other hand. Keep the button pressed until beeps are
heard (after 2 seconds approximately). The number of beeps (1, 2
or 3) indicates the mode which has been set, see below.
1 beep The button will beep and flash 5 seconds after being
pressed (this mode allows the cancelling of accidental
pressing).
2 beeps Respond to a single press instantly by triggering an
alarm and sounding a single beep.
3 beeps Respond to a single press instantly and silently by
triggering an alarm.
Choose the desired function by repeating steps 2 and 3, then
reassemble the button. This configuration will not be affected by
normal battery replacement (reconfiguration is only possible in the
above way).
Testing the panic button
The signals received by the control panel from the RC-87 can be
checked and measured. See the control panel manual for details.
Controlling electrical appliances
The RC-87 can also be used with other Jablotron products which
communicate via Oasis radio protocol, e.g. the JA-80L wireless siren,
or relay receiving modules series UC-8x and AC-8x (see the manuals
of these particular products for details).
The RC-87 transmits the same kind of signal as transmitted when
a pair of buttons is pressed simultaneously on an RC-80 keyfob.
The RC-87 can be enrolled to several receivers at once, e.g. alarm
triggering can also cause lights to be turned on.
Battery replacement
The button unit monitors its battery voltage and if too low, a report
is sent to the control panel to inform the installer or user. A critical
voltage level is also indicated by an LED flashing fast 3 times every 5
minutes. The battery should be replaced as soon as possible. As with
configuration, the button can be opened by unscrewing the 4 screws
from the bottom part. We recommend battery replacement be done by
a service technician.
Expired batteries should not be thrown into the garbage, but
disposed of according to local regulations.
Technical specifications
Voltage lithium battery type CR 2032 (3.0 V / 0.2 Ah)
Typical battery lifetime approx. 3 years (for 1 daily activation maximum)
Communication band 868 MHz, Oasis protocol
Communication range approx. 50 m (open area)
Environment external protected
Housing IP-44
Operational temperature -25 to +50 °C
Can be operated according to ERC REC 70-03
Complies with EN 300220, EN 50130-4, EN 55022,
EN 60950-1, EN 50134-2
FCC ID VL6RC87
JABLOTRON ALARMS a.s. hereby declares that the RC-87 is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC and complies with part 15 of
the FCC rules. Operation is subject to the following two
conditions: 1. This device may not cause harmful interference,
and 2. This device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Changes or modifications no expressly approved by
Jablotron could void the user´s authority to operate the
equipment. The original of the conformity assessment can be
found at www.jablotron.com, Technical Support section.
Note: Although this product does not contain any harmful
materials we suggest you return the product to the dealer or
directly to the producer after use. See www.jablotron.com for
details.
42
46
England 
Deutschland 
France 
Italia 
Polska 
United Kingdom 
Россия 
Nederland 
España 
Magyarország 
Sverige 
România 
Portugal 
Colombia 
Suomi 
New Zealand 
Česká republika 
Türkiye 
Danmark 
日本